Emerson ASTEC Helios Candeo AP6C75AA, Руководство по установке

Страница: 77 / 96

77
Helios Candeo Power System – AP6C75AA Installation Manual
6. End of job routines and turnover
6.1. General
This Chapter covers the job routines to be performed towards the end of the
installation project to ensure that the finished product meets all Astec Advanced
Power Systems and Customer standard requirements.
6.2. Designation
Designation is a process by which all power circuits and equipment are stamped
for proper identification, fast locating and future maintenance.
It can be done with a manual designating kit using individual rubber stamps with
paint or ink, with an electronic designating kit using stick-on ribbon, or with
individual stick-on letters and numbers.
Verify with the customer for the acceptable method(s). Some customer may
even have color preferences for the designation. If the Customer has no
preference, other factors may govern the final choice, such as consistency with
existing equipment, availability of a particular designating kit, etc.
The smallest acceptable character size is 3/16”.
Stamp the equipment as described in the following sections and according to the
information in the drawings and specifications.
6.2.1. Frame numbering
When adding the AP6C75AA Helios Candeo frame(s) to an existing lineup or
starting a new lineup in a power equipment room with existing equipment, the
designation should match the existing stamping (method, color and size) for
consistency, unless the Customer or the specification says otherwise.
The type of frame used for the AP6C75AA Helios Candeo power system is
usually stamped at the front and rear of the frame, at the bottom, as shown in
the following illustration.