Replacing or Adding a Disk Module
3-11
Servicing and Upgrading a CX200-Series DPE2
Removing a Disk Filler Module
Locate the slot where you want to install the disk module, and
remove the filler module, as shown in Figure 3-6.
Figure 3-6
Removing a Disk Filler Module
Skip to the disk installation procedure (page 3-12) to install the
add-on disk in the slot you just emptied.
Removing a Disk Module
CAUTION
!
If a disk module has been bound into a LUN, do not move it to
another slot unless you do not care about the data on the LUN. Each
module has LUN-identifying information written when it is
bound. Moving it to another slot can make information on the
original LUN inaccessible.
The disk modules in slots 0-3 (CX200 enclosure) or 0-2 (CX200LC)
provide mirrored boot capability and are preloaded according to
their slot assignment before shipment. Do not move a preloaded
module from its assigned slot to another slot, and remove it only to
replace the disk.
EMC2210
Содержание CX200-Series
