EMBRON Hatteland HT20 70 Series, Руководство пользователя

Страница: 37 / 154

37
IND100133-82
Physical Connections
AC Power INPUT (For units supporting AC input):
The internal AC power module supports 100-240V AC - 50Hz/60Hz using a standard IEC European power plug. See
specifications for more information.
1 x DC POWER INPUT (For units support DC input):
Connect your DC power cable to the Terminal Block 5.08 connector. The internal DC power module supports 24VDC.
For more information, please review “Housing Connector Overview” earlier in this manual.
NOTE: For HT20470 computer with DC Power Input, user must install and use the Cable Housing, KGG-MSTB 2,5/ 2
1803934 to be compliant with test reports in addition, mounted to the DC Power 2-pin plug. See instructions for
mounting in the “Configuring Housing / Terminal Block connectors” section earlier in this manual.
GROUNDING SCREW:
Please review “General Installation Chapter”, pt. 6 for more information.
Note for Grounding Screws:Standard Grounding Screw/Bolt provided by Hatteland Technology is “Pan head screws
M4x8mm w/spring and plainwasher”.
1 x COM (RS-232/422/485) Serial Port INPUT/OUTPUT:
Supports RS-232 or RS-485/422 using D-SUB 9P connector (male) connectors. Fasten the cable to the connector
using the provided screws on the cable housing itself. For configuration, please review the Appendix chapter, section
“BIOS - On-board COM Ports Configuration”.
2 x DisplayPort (DP) OUTPUT:
Connect your DP (male) cable to the DisplayPort (v1.2) 20P connector (female) on the rear side of the unit. The DP
has its own locking mechanism that locks the plug inserted. Make sure the plug “clicks” into place to verify a proper
and secure connection. Additionally to add extra security, a Screw Lock in the chassis above the DP port is available if
your DP cable supports it.
Note: Signal Output can be used together with additional graphics card installed in one of the PCIe slots. Please
review Appendix Chapter “BIOS - Hybrid Multi Monitor Configuration”. Both active and passive DP to DVI adapters are
supported. For setups requiring three DVI-D outputs, an active DP to DVI adapter must be used. Passive adapter can
only be used for setups with max two DVI-D signals.
4 x Network INPUT/OUTPUT:
Supports 10/100/1000Mbps Ethernet (LAN) through either 2 x Intel® or 2 x Realtek driver based. All 4 LAN connectors
can be used at the same time. Suitable for twisted pair cables CAT.5E. Make sure the network cable connector ”clicks”
into the RJ-45 connectors.