EMBRON Hatteland HT20 70 Series, Руководство пользователя, Страница: 21 / 154

21
General Installation Recommendations
Installation
IND100210-73
Configuring Housing / Terminal Block connectors
Below is a brief illustration that might be useful during configuration and installation of such connectors. You will need
suitable pre-configured cable(s) and tools to configure the connector(s) and cable(s) that are present in your
installation environment. Below is a sample procedure for a 2-pin DC power connector. The procedure is the same for
other connectors of this type as listed in table above. Unit used as illustration below is for reference only.
FIG 1
FIG 4
FIG 2
FIG 3
FIG 6
FIG 7
FIG 8
FIG 9
FIG 5
Requires assembly. It is expected that the technician has experience in electronics and assembling cables and connectors.
Warning:
Do not connect or disconnect cables/connectors to the unit’s connector while the unit is powered on. Failure to do so may result in
damaged electronics.
FIG 1: Unscrew (from top) or make sure that the screw terminal is fully open, so you can secure the inserted cables
correctly to the loose housing connector (it may already be plugged into the unit as per factory installation).
FIG 2: Strip carefully the insulation from the cable to expose the wire(s) inside.
FIG 3: Ensure that the wire(s) is without any loose threads to ensure good connection.
FIG 4: Insert cables* (from front) and screw / secure the cables by turning the screw on top of the housing to secure
the cables properly. Check that the cables are firmly in place and do not appear loose or fall out when pulling gently.
*Note: Required polarization verification (for instance -/+ for DC power input) should conform with the markings on
the connector area of the unit. Ignoring the markings on the unit or its add-on modules might damage the unit and/or
external equipment in which end, warranty will be void.
FIG 5: Place the connector between the housing parts and assemble housing cable.
FIG 6: Make sure the cables are not loose and is exiting the cable house correctly as illustrated.
FIG 7: Use a strips cable to ensure the stability of the housing cable.
FIG 8: Plug the housing into the appropriate connector area of the unit and check again that the cables secured
confirm with the markings on the connector area of the unit. Finalize the installation by fastening the screws located in
front on each side of the housing connector (FIG 9).