EMAK IP 1900, Инструкция для оператора

Страница: 26 / 168

26
WARNING
• It is important to remember that the high pressure cleaner is still operational when it is in Total Stop
mode. Therefore, always put the main switch (1) in position “0”, remove the plug from the power outlet,
press the lever (33) on the cleaner gun to eliminate any remaining pressure and lock the safety protection
device (32) (Fig. 2 – position s), before leaving it unattended, even for a short time.
Note 5 : during use with operating pressure in excess of 20 bar/290 psi (i.e. when the Total Stop device
is operational) if switch (1) is put into position ”0” for any reason (and lever (33) on the cleaner gun is
not being operated to eliminate any remaining pressure) the next time the switch (1) is put into position
”1”, the high pressure cleaner will not begin to start up as it is already ready for normal operation. Press
lever (33) on the cleaner gun to start operating the high-pressure cleaner.
6 Switching Off And Storage
After cleaning, switch the high-pressure cleaner off and prepare it for storage.
6.1 Switching off
• Close the tap for the water supply securely.
• Empty the water out of the high-pressure cleaner by pressing the lever (33) on the cleaner gun for a few
minutes.
• Put the main switch (1) in position “0”
• Remove the plug from the power outlet.
• Press the lever (33) on the cleaner gun to eliminate any remaining pressure in the high-pressure pipe (30).
• Wait for the high pressure cleaner to cool down.
WARNING
• When the high-pressure cleaner is left to cool down, take care that:
- the high-pressure cleaner is not left unattended in the presence of unsupervised children, elderly or
disabled people.
- the high-pressure cleaner is in a stable position and not at risk of falling over.
- the high-pressure cleaner is not in contact with inflammable materials, or in their immediate vicinity.
6.2 Storage
• Wind up the high-pressure pipe (30) carefully and avoid bending it.
• Wind up the electric power supply cable (14).
• Put the high-pressure cleaner in a clean and dry place making sure that the electric power supply cable
and the high-pressure pipe are not damaged.
CAUTION
• The high-pressure cleaner is not frost proof.
In order to prevent the formation of ice inside the high-pressure cleaner in cold areas, it is possible to
make the high pressure cleaner take up a motor vehicle grade anti freeze before starting the
“ Switch
off ”
procedures. Contact a
Skilled Technician
before attempting this as the pumped liquid could
damage the seals in the high-pressure pump.
If it is not possible to protect the high pressure cleaner in cold areas as described above, it must be
brought into a warm room for the time required to melt any ice which may have formed inside it
before attempting to start it up again.
If these instructions are not followed, the high pressure cleaner may be seriously damaged.
7 Cleaning and maintenance
WARNING
• Only start cleaning and maintenance once the instructions in the “Switching off” section have been
completed.
It is particularly important to always disconnect the electricity supply.
• To safeguard the safety of the high pressure cleaner, only use the original spare parts supplied by the
Manufacturer or those endorsed by him.
• The rubber pipes, the coupling and the high-pressure lances are important for safety: only use those
endorsed by the Manufacturer.