46
47
6 S
WITCHING
O
FF
AND
S
TORAGE
After cleaning, switch the water cleaner off and prepare it for storage.
6.1 S
WITCHING
O
FF
•
Close the tap for the water supply securely.
•
Empty the water out of the water cleaner by pressing the lever
(9)
on the cleaner gun for a few
seconds.
•
Put the main switch
(1)
in position
“0”
.
•
Remove the plug from the power outlet.
•
Press the lever
(9)
on the cleaner gun to eliminate any remaining pressure in the high-pressure
pipe
(7)
.
•
Rewind the power supply cable
(2)
with care and hook it to its support
(21)
.
•
Wait for the high pressure cleaner to cool down.
fi«
CAUTION
•
When the water cleaner is left to cool down, take care that:
-
the water cleaner is not left unattended in the presence of unsupervised children, elderly
or disabled people.
-
the water cleaner is in a stable position and not at risk of falling over.
-
the water cleaner is not in contact with inflammable materials, or in their immediate
vicinity.
6.2 S
TORAGE
•
Wind up the high-pressure pipe
(7)
carefully and avoid bending it.
•
Wind up the electric power supply cable
(2)
.
•
Put the water cleaner in a clean and dry place making sure that the electric power supply cable
and the high-pressure pipe are not damaged.
WARNING
•
The water cleaner is not frost proof.
In order to prevent the formation of ice inside the water cleaner in cold areas, it is possible to
make the high pressure cleaner take up a motor vehicle grade anti freeze before starting the
“
Switch off”
procedures. Contact a
Skilled Technician
before attempting this as the pumped
liquid could damage the seals in the high-pressure pump.
If it is not possible to protect the high pressure cleaner in cold areas as described above, it must
be brought into a warm room for the time required to melt any ice which may have formed
inside it before attempting to start it up again.
If these instructions are not followed, the high pressure cleaner may be seriously damaged.
7 C
LEANING
AND
M
AINTENANCE
fi«
CAUTION
•
Only start cleaning and maintenance once the instructions in the “
Switching off”
section have
been completed.
It is particularly important to always disconnect the electricity supply.
•
To safeguard the safety of the high pressure cleaner, only use the original spare parts supplied
by the Manufacturer or those endorsed by him.
•
The rubber pipes, the coupling and the high-pressure lances are important for safety: only use
those endorsed by the Manufacturer.
Содержание IP 1600
