EM HDEm 401 basic line, Руководство по эксплуатации

Страница: 14 / 52

Before starting any work the machine, unplug the power cable, turn off the water supply and actuate the spray
gun until the pressure has been relieved completely.
10
TROUBLESHOOTING
Undertake only the maintenance operations described in the user instructions.
Contact the Technical Assistance service for all other interventions.
Use only original spares.
Should the power cable be damaged, it must be replaced by a cable or a set of special cables available from
the manufacturer or its assistance service.
The pins and joints of the connection cables of the electrical system must be protected against accidental water
sprays.
STORAGE
Store the appliance in premises protected against freezing conditions.
If freeze protection is not guaranteed, suction a glycol based anti-freeze into the pump, as for cars
- Immerse the water pipe into the container of anti-freeze
- Immerse the gun without the sprayer nozzle into the same container
- Insert the appliance with open gun
- Activate the gun until an even jet is obtained.
Store the rest of the anti-freeze in a closed container.
Fault Cause Remedy
Pressure fl uctuates or drops Lack of water Turn on water supply
Water fi lter clogged
Clean the water fi lter on the
pump supply tube.
Motor hums when switched on,
but does not start
Mains voltage too low Check electrical connection
Spray gun not actuted
On switching on the machine,
engage the gun
Cross-section of extension lead
too small
Use correctly dimensioned exten-
sion lead, see “Connect machine
to power supply”
Motor will not start when switched
on
Power supply not OK Check plug, cable and switch
Mains fuse tripped Resert mains fuse
Motor stops
Motor protection switch tripped
due to motor overheating
Check that power supply matches
appliance voltage, wait 3 minutes,
then switch machine on again
The detergent fails to come out Clogged injector
Clean the detergent spray nozzle
element
Jet is ineffective, ragged unstea-
dy Clean the nozzle of the foam
launch
Clean the high pressure nozzle.
Selector sleeve for type of jet
wrongly set
Adjust selector sleeve
Treatment of waste from electric/electronic equipment
Dispose of the product in accordance with current regulations concerning differentiated waste disposal
in dedicated waste disposal areas. Do not treat as simple urban waste.
For any information please contact the manufacturer at the address specified in the user manual.
The product complies with the requirements of the new directives introduced for the environmental safeguard
and must be disposed of appropriately at the end of its life cycle.
N E
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com