EM HDEm 401 basic line, Руководство по эксплуатации

Страница: 13 / 52

6
APPLIANCE ACTIVATION
Operate the equipment in vertical position
only after connecting the water supply pipe
and turning on the tap (fig.
2
)
Connect a clean water supply pipe (Fig.
– pos. 3 ) to the water mains, checking
to ensure that the minimum pressure is of
1.5 bar and maximum is of 6 bar, with a
minimum flow rate of 7 l per min.
- Connect the water supply pipe (min. diam ½”) to
the water mains (fig.
3
)
- Fit the click-on attachment
(Fig. 4 - pos. 1 )
onto the fitting
( 2 )
;
4
HIGH PRESSURE PIPE CONNECTION
- Insert the high pressure pipe (Fig. -pos. 3 ) into
appliance attachment (
4
)
- Rotate the plastic ring nut, thoroughly tightening it
- Turn on the water tap
Assembly of the detergent spraying device
(Fig. 6)
- Insert the nozzle into the spray gun
- Rotate the nozzle by 90°, and on extracting it,
click it in.
3
CONNECTION OF THE WATER SUPPLY
PIPE
8
ACCESSORIES
7
SWITCHING OFF THE MACHINE
- Press the button marked with an
0
on the switch
(Fig.
7
-
OFF
)
- Turn off water supply tap.
- Actuate spray gun until water drips from the nozzle
(machine is now de-pressurized).
- Release trigger.
- Press safety latch on spray gun. (Fig.
9
). The spray
gun is locked and cannot be actuated accidental-
ly.
- Unplug machine from socket outlet.
- Disconnect water supply hose from machine and
water supply mains.
-
Position the spray gun on the object to be
cleaned - never on people !
- Press the safety device (Fig.
8
- pos.
1
) - the gun is
released
- Direct the nozzle downwards (Fig.
2
)
- Fully press down the trigger (Fig.
8
- pos.
2
)
5
ELECTRICAL CONNECTION OF THE
APPLIANCE
The mains voltage must match the operating voltage.
(See identification plate)
- Insert the plug into a power socket installed in
compliance with regulations.
Check the minimum section of the individual cables
using extensions.
Position the extensions so as to maintain the protection
class of the equipment.
Voltage Cable Cross-section
V length m mm
2
230 up to 2 1,5
230 20 to 5 2,5
The detergents must not be al-
lowed to dry on the object to be
cleaned.
- Remove the nozzle by pushing it towards the
spraying gun, rotate it 90° and take it out.
(Fig.
10 ).
11 ).
12 ).
13 ).
- Fill the container of the foam nozzle with suitable
detergent (see paragraph “General safety recom-
mendations” in this booklet) (Fig.
- Apply the foam nozzle to the gun (Fig.
- After using the foam dispenser, hang it on the hook
on the rear of the machine (Fig.
ozzle
The nozzle ( 6 - Fig. 1 ) cannot be adjusted
Turbo nozzle
(
13
- Fig.
1 - optional
)
The turbo nozzle, is ideal for maximizing cleaning,
cannot be adjusted.
ADDITION OF DETERGENT
- Press button I (Fig. 7 - ON ) on the main switch posi-
tioned at the of the device
9
MAINTENANCE, REPAIRS
AND STORAGE
Before undertaking any
work on the appliance
always detachthe plug from
the power socket
N E
5
5
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com