34
Installation
© 2021, Elon Group AB. All rights reserved.
1.
Loosen the bolts with a spanner and remove them.
2.
Plug the holes with the transport hole plugs.
3.
Keep the bolts in a safe place.
NOTE! You will need the transport bolts again if you move the machine.
Level the machine
1.
Loosen the nuts and screw in the feet fully.
Check if there are any feet not touching the floor.
2.
If any foot is not touching the floor: screw out the foot until it makes contact with the floor.
3.
Use a spirit level to check if the dryer is perfectly level and adjust the feet again if needed.
4.
Tighten the nuts with a spanner and make sure that the machine is steady.
WARNING! The lock nuts on all four feet must be screwed tightly against the housing.
