46
47
© 2021, Elon Group AB. All rights reserved.
INSTALLING YOUR NEW APPLIANCE
•
Before using the appliance for the first time, you should
take note of the following tips.
•
•
Ventilation of appliance
•
To improve efficiency of the cooling system and save
energy, it is important to maintain good ventilation around
the appliance for the dissipation of heat. Sufficient clear
space should therefore be provided around the freezer.
•
Recommendation: It is advisable for there to be 50–70
mm of space between the back of the appliance and the
wall, at least 100 mm above the appliance, at least 50
mm between either side and the wall, and a clear space
in front to allow the door to open 135º. As shown in the
following diagrams.
Note:
•
This appliance performs well within the climate class
shown in the table below.
•
It may not work properly if it is left at a temperature above
or below the indicated range for a long period.
Climate class
Ambient temperature
SN
+10°C to +32°C
N
+16°C to +32°C
ST
+10°C to +38°C
T
+10°C to +43°C
•
Place your appliance in a dry place to avoid high moisture.
•
Keep the appliance out of direct sunlight, rain or frost.
Stand the appliance away from heat sources such as
stoves, fires or heaters.
Levelling the appliance
•
To level the appliance and ensure sufficient air circulation
in the lower rear section of the appliance, the bottom feet
may need to be adjusted. You can adjust them manually
by hand or by using a suitable spanner.
•
To allow the door to self-close, tilt the top backwards by
about 10 mm.
Installing the door handle
For ease of transportation, the door
handle are provided separately in a plastic bag. You can
install the door handle as follows.
1. Prise off the screw covers on the right side of the door, and
put them back in the plastic bag.
2. Position the handle on the right side of the door, keeping
the holes in the handle aligned with the holes in the door,
as illustrated.
3. Fix the handle with the special screws provided in the
plastic bag. Then install the handle covers.
Reversing the door
The side at which the door opens can be changed, from the
left side (as supplied) to the right side, if the installation site
requires.
Warning!
When reversing the door, the appliance must not be
connected to the mains. Ensure that the plug is removed from
the power socket.
Tools you will need:
Note:
Before you start, lay the freezer on its back in order
to gain access to the base. You should rest it on soft foam
packaging or similar material to avoid damaging the back of
the freezer.
To reverse the door, the following steps are generally
recommended.
1. Stand the freezer upright.
50-70mm
8 mm socket wrench
Thin-bladed screwdriver
8 mm spanner
Cross-head screwdriver
Содержание CFS5185V
Страница 95: ...95 2021 Elon Group AB All rights reserved...