WB-2P-LR2. User manual
39
•
•
•
•
•
•
5.2.3 The 'LAN' submenu
In DHCP server settings section you may configure local network, DHCP server, set static addresses bindings.
The device is capable to assign IP addresses and other parameters required to the Internet access to computers
connected to LAN interface through DHCP (Dynamic Host Configuration Protocol). The use of DHCP allows to
avoid manual configuration of TCP/IP.
LAN:
IP address
– IP address of the device in a local network;
Netmask
– subnetmask in local network.
DHCP server settings:
Enable
– when cheked, a local DHCP server is enabled, otherwise the server is disabled;
Start IP address
– the initiate address of the IP addresses pool;
Pool size
– number of addresses in the pool;
Lease
time (min)
–
set the maximum time range for using an IP address assigned by DHCP server, lease
time is set in minutes.
To apply a new configuration and store settings into the non-volatile memory, click the
'Apply' button.
To discard
changes click the
'Cancel' button.
The 'LAN' submenu is available only in the 'Router' mode.
When you try to change the starting address of the DHCP pool to an address from a different subnet with
respect to the subnet of the LAN interface, the pool is automatically set in accordance with the specified
local subnet.
