WB-2P-LR2. User manual
36
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Alternative Vendor
ID (Option 60)
– when selected, the device transmits
Vendor
ID (Option 60) in
Option 60 DHCP messages (Vendor class ID).
If the field is empty, Option 60 will not be transmitted in
DHCP messages.
If the parameter Alternative Vendor ID (Option 60) is not checked, the defualt value will be transmitted
in option 60. The default value has the following format:
[VENDOR:device vendor][DEVICE:device type][HW:hardware version] [SN:serial number][WAN:WAN
interface MAC address][LAN:LAN interface MAC address][VERSION:firmware version]
Example:
[VENDOR:Eltex][DEVICE:WB-2P-LR2][HW:1.2][SN:WP29000038] [WAN:E0:D9:E3:75:55:60]
[LAN:E0:D9:E3:75:55:60][VERSION:2.0.0.161]
Primary DNS, Secondary DNS
– DNS Ip address – if DNS addresses are not automatically assigned via
DHCP, you should defined them manually.
VLAN Trunk –
if checked, the trunk port is activated for connected devices. There is an opportunity to use
Management VLAN:
Use Management VLAN
–
when checked, management VLAN used for access to the device is
enabled:
Management VLAN ID
– VLAN identifier, which is used to access the device;
Management 802.1P
– 802.1P attribute (also called CoS – Class of Service), which is attached
to egress packets transmitted from this interface. The value is from 0 (the least priority) to 7
(the highest priority).
Management VLAN Access
– restrict access to the management network. Possible values:
Ethernet and wireless
– access to the management network is possible from the wireless
and Ethernet interfaces;
Wireless
– access to the management network is only possible from the wireless
interface side.
Limit VLAN-list
– when checked, the device in VLAN trunk mode will pass only a limited number of
VLANs, which are specified in the "VLAN list" field.
VLAN list
– contains VLAN identifiers that are allowed for transmission. Accepts values from 1
to 4094, it is possible to specify a range, for example "2000-2010".
WDS Settings
Security mode
– select security mode for wireless bridge:
Off
– wireless network encryption is off, low security;
WPA2
– WPA2 authentication. The length of the key makes from 8 to 11 characters. Only the
following characters can be used: a-z, A-Z, 0-9, ~!@#$%^&*()_-+=;:
|/?.,<>"`' or space.
Link X (where X=0..7)
– enable wireless bridge link. Enter MAC address of the device, to which you want to
configure the wireless bridge, to a corresponding field next to Link checkbox.
