INSTALLATION
023.
INSTALLATION WAY
PLEASE HAVE THE WIRING CONNECTION OF THE POWER SUPPLY, SPEAKERS AND ANTENNA AS FOR THE
REQUIREMENT OF THE MANUAL, THEN INSTALL THE METAL SLIDING HOUSING INTO THE CAR ACCORDING TO THE
DIAGRAM.
TO BOOST UP THE CAPABILITY OF
ANTI-JAMMING, PLEASE FIX THE
METAL STRAP ON THE METAL
CONNECTED TO THE BOTTOM
BRACKET OF THE CAR.
TO DRAW THE CHASSIS OUT OF THE SLIDING
METAL HOUSING, INSERT THE LEFT AND RIGHT
KEY PLATES INTO THE RIGHT POSITION OF THE
2 SIDES OF CHASSIS.
PRESS RESET BUTTON TO RESUME
THE DISTORTED PROGRAM WHEN
THE LCD DISPLAY IMPROPERLY AND
SOME BUTTONS ARE INVALID.
TO REMOVE THE FRONT PANEL
AWAY FROM THE CHASSIS,
FIRSTLY PUSH THE FRONT PANEL
HOLD RIGHTWARDS.
THEN PULL THE LEFT SIDE OF
THE FRONT PANEL OUTWARDS.
TO INSERT DISC INTO COMPARTMENT OR EJECT DISC OR
REMOVE THE FRONT PANEL AWAY FROM THE CHASSIS, PRESS
THE OPEN BUTTON TO FLIP DOWN THE FRONT PANEL.
REMOVE THE SLIDING
METAL HOUSING
AWAY
REMOVE AWAY 2 SCREWS FOR
PROTECT THE DECK BEFORE
OPERATING IT.
TO INSTALL THE FRONT PANEL BACK TO THE UNIT CHASSIS,
FIRSTLY MAKE THE LEFT GUIDE BLOCK HOLE AND THE LEFT
CYLINDER LINE UP AND THEN COMBINE THEM.
THEN MAKE THE RIGHT GUIDE BLOCK HOLE AND THE RIGHT
CYLINDER LINE UP AND THEN COMBINE THEM.
FINALLY FLIP THE FRONT PANEL UP TO COMBINE WITH
CHASSIS.
METAL STRAP
DASH BOARD
SELECT THE PROPER
FIXER FOR FIXING THE
SLIDING METAL HOUSING.
UNIT CHASSIS
PLASTIC TRIM OUT
FRONT PANEL
EJECT BUTTON
RESET BUTTON
SLIDING METAL HOUSING
NOTE
01-7538N-GE-EN 7/29/06 11:45 AM Page 023
