elsner elektronik 70550, Установка и настройка

Страница: 46 / 52

44 Parameter setting
Actuator KNX S1R-B4 compact • Version: 12.09.2022 • from application 1.0 • Technical changes and errors excepted.
Drive channel A is Master, zero position sensor via bus,
drive channel B is Slave, zero position sensor via bus:
5.2.3. Channel settings – switch functions
If two switchable devices are connected to the output channel, two separate channels
will appear (e.g. "Channel A1 – switch function" and "Channel A2 – switch function").
First set the general specifications for the connected device and, if necessary, activate
the connections, time functions and blocking objects. A diagram is found in chapter
Channel settings – switch functions , page 44.
Relay operation closer • opener
Behavior after reset and ETS download • opened
• closed
Use status object • no
• as an active feedback object
• as a passive status object
Use connection function
(see
Connection (switch functions) , page
45)
no • yes
Use time function
(see
On/Off switch delays, time switching
(switch functions) , page 45)
• no
• as a switch on delay
• as a switch off delay
• as a switch on and off delay
• as a staircase light timer
Use blocking object no • yes
Use scenes no • yes
zero position zero position
of drive 1 of drive 2
Master
Drive 1
at channel A
Slave
Drive 2
at channel B
Master command
Master zero position status
Slave zero position status
68
67
71
70
69 72
Zero position reached
65 65
sensor sensor