elsner elektronik 70119, Установка и настройка

Страница: 17 / 24

15 Setting of parameters
Brightness sensor KNX L • Status: 20.12.2019 • Technical changes reserved. Errors reserved.
6.2.1. Brightness threshold value 1 / 2 / 3
Threshold value
If the threshold value is set per Parameter:
If the threshold value is set per Communication object:
Switching output
Threshold value setpoint per Parameter • Communication object
Threshold value setpoint per Parameter
Threshold value in klux 0 … 99; 60
Hysteresis of the threshold value in % 0 … 50; 20
Threshold value setpoint per Communication object
The value communicated last shall be
maintained • not
• after restoration of voltage
(der geänderte Grenzwert kann
mindestens 100.000 Mal gesichert
werden)
• after restoration of voltage and
programming (Attention: Do not use for
first commissioning)
Start threshold value in kLux
valid until 1. communication
(only if the value communicated last is
„not“ maintained or „after restoration of
voltage“)
0 … 99; 60
Type of threshold change • Absolute value with a 16 bit
communication object
• Increment / decrement with one
communication object
• Increment / decrement with two
communication objects
Step size
(only if sending „Increment/decrement“)
1 klux • 2 klux • 3 klux • 4 klux • 5 klux • 10
klux
Hysteresis of the threshold value in % 0 … 50; 20
Ausgang ist bei
(TV = Threshold Value) • TV above = 1 | TV - Hyst. below = 0
• TV above = 0 | GW - Hyst. below = 1
• TV below = 1 | GW + Hyst. above = 0
• TV below = 0 | GW + Hyst. above = 1
Switching delay from 0 to 1 none • 1 sec … 2 h
Switching delay from 1 to 0 none • 1 sec … 2 h