ELSA LANCOM Wireless L-II, Руководство пользователя

Страница: 36 / 71

Configuration and management
|
|
ELSA LANCOM Wireless L-II
|
36
EN
ELSA WEBconfig
Launch your browser and enter the device's IP address, which you configured
in the basic settings, into the address field. If you did not specify an IP
address while configuring the basic settings, the address is 'http://
10.0.0.254'.
There is a link on the start page called 'Upload New Firmware'. In the next
window, you can search for the firmware file in the directory index and then
click the
Upload button.
TFTP
With TFTP you can use the writeflash command to install new firmware. To
transmit a new firmware version to a device with the IP address
194.162.200.17, you would enter the following command under Windows NT
for example:
tftp -i 194.162.200.17 put lc_wl1iu.200 writeflash
This command sends the corresponding file to the input IP address using the
writeflash command. Binary file transfer must be set for TFTP. However,
many systems have the ASCII format preset. This example for Windows NT
shows you how to achieve this by using the '-i' parameter.
The device is booted up following a successful firmware upload and this
activates the new firmware switch directly. If an error occurs during the
upload (write error in the flash ROM, TFTP transmission error or similar)
FirmSafe activates the previous firmware. The configuration remains in
operation.
With TFTP, other configuration commands can be performed too. The syntax
is best demonstrated with the following examples:
tftp 10.0.0.1 get readconfig file1: Reads the configuration from the device
with the address 10.0.0.1 and saves it as file1 in the current directory.
tftp 10.0.0.1 put file1 writeconfig: Writes the configuration from file1 to
the device with the address 10.0.0.1.
tftp 10.0.0.1 get dir/status/verb file2: Saves the current connection
information in file2.
100235 Wireless L-11.book Seite 36 Montag, 30. Oktober 2000 5:43 17