Mode when started up
Reception enabled from Infrared remote control
Mode when started up
Reception disabled from Infrared remote control
Mode+Output 4
Sets up last output as PREVIEW
Mode+Output 4
Sets up last output as normal operation
PLEASE NOTE
By setting up the last output as PREVIEW
the Output button LED 4 stays on.
The operation of output 4 is standard when the LED is off.
6.0 INFRARED REMOTE CONTROL
The unit is supplied with a receiver for the infrared remote control. The remote control
must be ordered separately (Code IRTZM443).
PLEASE NOTE
The remote control is of the self-learning type. After putting in
the batteries and after each replacement, press the “SET” button for a few seconds
followed by the purple bordered key
(OUT2)
PLEASE NOTE
The reception from the remote control can be enabled and disabled by holding
down (during startup) the MODE button on the front panel of the TZM443.
The TZM443 has been factory-set with remote control enabled
The following functions can be carried out with the infrared remote control:
Save + IN 1
÷
4
Saves a configuration with
IN
keys
1
÷
4
OUT 1
÷
4
Recalls a configuration with
OUT
keys
1
÷
4
PLEASE NOTE
Recalling a preset from the keypad or from the remote control
also sets up the same configuration as a restart
IN keys 1
÷
4
Selects inputs (or selects Save N°)
OUT keys 1
÷
4
Selects outputs (or selects Recall N°)
A, V, A+V, Lock
Switching mode setup
MUTE video ON OFF
Sets up MUTE on video preview output
MUTE audio ON OFF
Sets up MUTE on audio preview output
PLEASE NOTE
The INPUTS-OUTPUTS sequence must also be carried out from the remote control.
In other words, the source must be selected before the destination.
TZM443
4x4 HIGH RES. & AUDIO MATRIX
ELPRO Video Labs s.r.l.
Via della Praia, 4/A 10090 Ferriera di Buttigliera Alta (TO) ITALY
Tel.+39 0119348778 – Fax +39 0119348779
8