ELNA eXperience 620, Руководство по обслуживанию

Страница: 21 / 38

19
MODEL: eXperience 620
C D
The window displays "1".
36 ± 3mm
STRETCH STITCH FEED BALANCE
When a stretch pattern is sewn with the feed balancing dial (C) set at the standard mark ( ), the
pattern should be as indicated with the "0".
1. Set up the machine in adjusting mode (see below).
2. Set the feed balancing dial at the standard setting mark ( ).
3. Check the sewing results (the standard figure length of five pieces of figure 8 is 33–39 mm).
4. Remove the 2 setscrews. Then remove the base cap.
5. If the length is longer than 39 mm, turn the adjusting screw in the direction of (C).
6. If the length is shorter than 36 mm, turn the adjusting screw in the direction of (D).
7. Reattach the base cap and tighten the setscrews.
Feed balancing dial
Standard setting
mark
TO ENTER THE ADJUSTING MODE:
Turn the power switch on while pressing
the"–" of stitch width button and "+" of
stitch length button.
Press the "–" of stitch width button.
Base cap
Adjusting screw
Setscrew