18
Adjustment of height and direction of presser bar
The clearance between the presser foot and the surface of the needle plate should be 6.0
mm when the presser foot is raised.
The presser foot should be parallel to the slot of the feed dog teeth when attached.
1. Raise the presser foot lifter.
2. Attach the zigzag foot A.
3. Set the foot pressure at “3”.
4. Drop the feed dog.
5. Remove the face plate (refer to page 1).
6. Loosen the setscrew on the presser bar supporter to
adjust the presser foot direction so that the slot for the
feed dog teeth and the zigzag foot should be parallel.
7. Place a 6 mm block between the presser foot and
the needle plate. Tighten the setscrew holding the
presser foot against the block.
8. Attach the face plate.
Setscrew
(2 mm width
across flats)
Presser
foot
Presser bar
supporter
Needle plate
Approximately
6.0 mm
Block
Slot
Should be
parallel
