66
Symptom
Possible cause/remedy
The image is striped.
• This may be interference fringes between dots of printed matter
and TV scanning lines or CMOS pixels. Changing the shooting
range may improve the problem.
• Vertical stripes may appear on an LCD projector image. Manually
adjusting the dot clock at the projector side may improve the
problem.
Images on the SD
card/USB flash drive
are not displayed.
• Remove the SD card/USB flash drive, wait a few seconds and
reinsert.
The image does not
move.
• The camera image is in pause mode. Press the Pause button on
the Operating panel again to cancel the pause.
The remote control
does not work.
• Battery power is low. Replace the coin batteries with new ones.
• The incorrect remote control is being used. Use the supplied
remote control.
After inserting the SD
card/USB flash drive,
operations cannot be
performed.
• The SD card/USB flash drive is not being read correctly. Use the
SD card/USB flash drive after formatting it twice as described
below.
• First, format the card using a computer. Second, format the card
using the product.
UVC image is upside
down.
Check that the graphics driver and other device drivers on your
computer are updated. The latest device drivers are available from
the computer manufacturer.
The displayed UVC
image contains images
other than the camera
image.
• The software and OS you are using or the connection status may
be causing images other than the camera image to break through
while displaying the camera image. This problem can be solved by
reconnecting the device or restarting the software.
A software error
message appears and
the UVC image is not
displayed
• If it is taking too much time for the preparation of the image output,
the software may determine this to be an error. Restart the
product, reconnect it to the computer, and then start the software.