Elmo 95VDC, Руководство по установке

Страница: 7 / 69

1.1 Warnings
To avoid electric arcing and hazards to personnel or electrical damage,
never connect/disconnect any plug or cable from the servo drive while
the power source is on.
Power cables can carry a high voltage, even when the motor is not in
motion. Disconnect the Duo from all voltage sources before it is opened
for servicing.
The Duo contains grounding conduits for electric current protection. Any
disruption to these conduits may cause the instrument to become hot
(live) and dangerous.
After shutting off the power and removing the power source from your
equipment, wait at least 1 minute before touching or disconnecting parts
of the equipment that are normally loaded with electrical charges (such as
capacitors or contacts). Measuring the electrical contact points with a
meter, before touching the equipment, is recommended.
1.2 Cautions
The Duo contains hot surfaces and electrically-charged components
during operation.
The maximum AC/DC power supply connected to the instrument must
comply with the parameters outlined in this guide. Furthermore, the power
supply must be isolated from hazardous live voltages using reinforced or
double insulation in accordance to approved safety standards.
When connecting the Duo to an approved 12 ~ 95VDC (8.5 ~ 67VAC)
auxiliary power supply, connect it through a line that is isolated from
hazardous live voltages using reinforced or double insulation in
accordance with approved safety standards.
Before switching on the Duo, verify that all safety precautions have been
observed and that the installation procedures in this manual have been
followed.
Duo Installation Guide Safety Information
MAN-DUOIG (Ver. 1.0)
1-2