Operation
5
Operation
Settings and adjustments of the parameters of the centrifuge are made on the turned on device with
opened or closed lid. Do not forget to use the aerodynamic, magnetic lid with the rotor.
During operation parameter adjustments are not possible.
Braking levels (15000 rpm, full rotor)
Level Seconds
1....................................................................................................................28
2....................................................................................................................20
3....................................................................................................................15
4....................................................................................................................13
5....................................................................................................................11
When all the parameters are entered to start the centrifuge close the lid and press the button.
If the settings were made with the lid closed then press the last set parameter button
, or and press the button.
Thus the centrifuge will start and the timer will begin the countdown. Last minute of countdown is displayed
in seconds. When the set time runs out centrifuge stops, alarms sounds and lid unblocks.
Centrifuge СМ-50 supports a special PUSH mode to make your work more effective
and a sleep mode to minimize power consumption.
PUSH mode is in the speed range before 1 or after 15. Duration of centrifugation in PUSH mode is
determined by the duration of button retention period, as soon as the button is released,
the centrifuge stops with the set the braking level.
SLEEP mode - device goes into sleep mode automatically after 25 minutes of standstill.
To exit sleep mode, just press any button.
ATTENTION! Do not forget to use the magnetic aerodynamic lid with the rotor!
1. Setting speed parameter:
Press the button and set the desired parameter value with buttons.
2. Setting time parameter:
Press the button and set the desired parameter value with buttons.
3. Setting brake level parameter:
Press the button and set the desired parameter value with buttons.
4. Modes: