Sagab by Elma 911
32
Replacing the battery
WARNING
: To avoid electric shock, disconnect the test leads from any source of voltage
before removing the battery door.
1.
When the batteries become exhausted or drop below the operating voltage, “BAT” will
appear in the right-hand side of the LCD display. The battery should be replaced.
2. Follow instructions for installing battery. See the Battery Installation section of this
manual.
3. Dispose of the old battery properly.
WARNING:
To avoid electric shock, do not operate your meter until the battery door is in
place and fastened securely.
BATTERY INSTALLATION
WARNING
: To avoid electric shock, disconnect the test leads from any source of voltage
before removing the battery door.
1. Disconnect the test leads from the meter.
2. Open the battery door by loosening the screw using a Phillips head screwdriver.
3. Insert the battery into battery holder, observing the correct polarity.
4. Put the battery door back in place. Secure with the two screws.
WARNING:
To avoid electric shock, do not operate the meter until the battery door is in
place and fastened securely.
NOTE
: If your meter does not work properly, check the fuses and battery to make sure that
they are still good and that they are properly inserted.
Replacing the fuses
WARNING
: To avoid electric shock, disconnect the test leads from any source of voltage
before removing the fuse door.
1. Disconnect the test leads from the meter and any item under test.
2. Open the fuse door by loosening the screw on the door using a Phillips head
screwdriver.
3. Remove the old fuse from its holder by gently pulling it out.
3. Install the new fuse into the holder.
4. Always use a fuse of the proper size and value (0.2A/250V fast blow for the 200mA
range, 10A/250V fast blow for the 10A range).
11. Put the fuse door back in place. Insert the screw and tighten it securely.
WARNING
: To avoid electric shock, do not operate your meter until the fuse door is in
place and fastened securely
MD 20130628 v1.1
