Elma JetKit-3010, Руководство пользователя

Страница: 39 / 44

USER MANUAL JetKit-3010 ELMA.COM
www.elma.com EMBEDDED BOARDS
4 Configuration
The board houses three 4 pole DIP switches as it can be seen in Figure 16.
Figure 16 - 4 pole DIP switch
The switch is active, when the switch is slid to the “ON” side of the housing.
Table 32 to Table 34 list the switch functionalities of the switches SW3, SW5 and SW6. Default
configurations are highlighted in light blue color.
Table 32 - DIP Switch SW3 Functionality
Switch Setting
1
OFF No automatic CLKREQ# input when board is in a system slot
ON CLKREQ# is automatically set as input when board is in a system slot
2
OFF No automatic CLKREQ# output when board is in a peripheral slot
ON CLKREQ# is automatically set as output when board is in a peripheral slot
3
OFF No manual configuration of CLKREQ# input
ON CLKREQ# is set as input
4
OFF No manual configuration of CLKREQ# output
ON CLKREQ# is set as output
Table 33 - DIP Switch SW5 Functionality
Switch Setting
1
OFF BMC programming mode (BMC reset connection)
ON BMC run mode (normal operation)
2
OFF Perform BMC soft reset when receiving reset input
ON Perform BMC hard reset when receiving reset input
3
OFF No hardware reset in to out propagation
ON Hardware reset in to out propagation
4
OFF Ethernet PHY always on
ON Keep Ethernet PHY in reset when plugged in a rear I/O backplane
Table 34 - DIP Switch SW6 Functionality
Switch Setting
1
OFF No auto power (wait for power button or wake input)
ON Auto power (only when operation from 5V standby is permitted)
2
OFF Run from main power only
ON Run from main power or from 5V standby
3
OFF BMC programming mode (BMC programming clock connection)
ON BMC UART to Quad UART connection (normal operation)
4
OFF BMC programming mode (BMC programming data connection)
ON BMC UART to Quad UART connection (normal operation)