Required Inspections-aerial1 EEC-0088
V1.4
Required Inspections
hanging out of the cable carrier as this will cause damage or a possible leak in
these components. Upon completing this check, retract the boom.
Check to see that there is adequate clearance before operating boom rotation.
Operate swing left and right, and then center the boom and operate boom down
to restore the boom to the boom stand. Move the ignition switch to the off
position until the engine stops. Turn on the 12-volt emergency pump (on units so
equipped) and raise and lower the boom a few inches to test the 12-volt
emergency pump. Restart the vehicle engine and test the motor speed control by
moving the switch up (momentarily) and down (hold). Finally, test the horn (if so
equipped). Test other optional systems that your unit may have such as remote
platform rotation, bucket rotation, jib winch or jib rotation.
D. Purge and Re-Level Platform Leveling System:
Raise the boom to the
horizontal position and operate the leveling valve in both directions to circulate
the oil in the closed leveling system and to purge air from the system. Re-level
the platform. Stop the vehicle engine and return the switch to run (center)
position.
Functional Check of Platform
A. Setup Procedures:
Check the data plate at the lower controls for the platform
weight rating (and insulating rating of the boom). Check on the lower control
panel that the switches are in
UPPER CONTROLS
position, the
ENGINE
SPEED
switch is in the center
IDLE
position and the engine switch is in the
center
RUN
position. The
OFF
position will prevent the engine from starting from
the platform (or from the cab with the Master Switch in the
ON
position).
B. Platform Controls:
Read and understand all warning, caution and notice labels
at the platform. Attach the safety harness lanyard to the labeled anchorage
loop(s). Make sure the lanyard length is proper for the job. On units so equipped,
attach the closure chain (or rope) across the platform opening. On units equipped
Содержание Traffic Safety Service L60
