Elliott Traffic Safety Service L60, Руководство оператора

Страница: 98 / 212

Required Inspections-aerial1 EEC-0088 V1.4
Required Inspections
on a side slope, the upper leg of the A outrigger must still be extended to the
stripe to prevent the unit from becoming unstable to the up-hill side. Use cribbing
under the down-hill leg if necessary.
Check the level bubble on the lower control panel bottom to ensure the bubble is
centered right-to-left. Adjust the outriggers down on the side away from where
the bubble is resting until the bubble is centered right-to-left.
Move to the secondary outrigger control valve (on units so equipped) and extend
and lower the secondary outriggers while watching to ensure that neither
outrigger shoe is coming down on any obstruction. NOTE: out-and-down
secondary outriggers must be fully extended to the green stripe before
lowering the legs. Both A outrigger legs must be extended to the green stripe.
When the unit appears level front-to-rear, check the level bubble. Continue to
adjust until the bubble is in the center of the indicator. Lower the front stabilizer
(on units so equipped) while watching under the vehicle to prevent lowering onto
an obstruction until the front of the vehicle starts to lift.
It is extremely important to recheck that all outriggers are on a firm surface and
some portion of the bubble is within the center mark of the level indicator. If the
bubble is not in the center of the level, first raise the front stabilizer (on equipped
units) and the secondary outriggers (on equipped units), then reset the main and
the secondary outriggers if equipped with front stabilizer. Always set front
stabilizer last. The outriggers must be set before the boom may be operated from
the stowed position.
C. Pre-Operational Check from Lower Controls: Check overhead clearance and
operate boom up to the horizontal position and rotate to a clear area. Check
clearance, and then telescope out. With the boom out, check that the boom is not
rusty and is coated with a light oil film. There should be no hoses or cables