Elliott Roto-Jet I 0620A, Инструкция по эксплуатации и техническому обслуживанию

Страница: 7 / 33

0620A Roto-Jet I
7
Wet Shafts (Fig.1)
Prefix Part Number Casing Outside Diameter Tube Inside Diameter
inch mm inch mm
0511*(xx) .250 6 5/16 - 3/8 8 - 10
0512*(xx) .375 10 7/16 - 1/2 11 - 13
0513*(xx) .500 13 9/16 - 1 14 - 25
0514A*(xx) .625 16 3/4 - 1-1/2 19 - 38
0514*(xx) .750 19 1 - 2 25 - 50
0515*(xx) 1.000 25 2 and over 50 and over
*Length of shaft in feet completes the part number.
(Available in standard lengths of 16’, 25’, 33’, and 49’. Consult factory for additional lengths.)
Dry Shafts (Fig.2)
Prefix Part Number Casing Outside Diameter Tube Inside Diameter
inch mm inch mm
0534*(xx) 7/8 22 1 and over 25 and over
*Length of shaft in feet completes the part number.
(Available in standard lengths of 25’, 35’, and 50’. Consult factory for additional lengths.)
SAFETY (CONT.)
23. Maintain Labels and Nameplates. These carry important information and will assist you in ordering
spare and replacement parts. If unreadable or missing, contact an Elliott service facility for a
replacement.
24. Stop the Machine Immediately if the Flexshaft Starts to Coil. Flexshaft damage will occur if flexshaft is
operated in a coiled position.
25. Use the Proper Flexshaft to fit the tubes to be cleaned. Never use a flexshaft that is too small or too
short. Flexshaft failure will result if too great a resistance is placed on the flexshaft. Refer to the chart
below for sizing information. (See Fig. 1 and 2)