LJNED10_2AQ
PAGE 7
1000002311 (Rev. D - 05/16)
CUP DISPENSER INSTALLATION INSTRUCTIONS
1. The Cup Dispenser
is designed to complement recessed drinking fountains. The fountain should
already be installed before beginning installation. If not, refer to page 2 for your model.
2. Check
wall opening to see if provisions have been made to accept this cup dispenser. If they have
not, refer to page 2 for rough-in instructions.
CAUTION:
Wall construction must be framed to
support fountain and cup dispenser (approximately 150 lbs or 68 kg).
3. Orientate
yourself to the configuration of the cup dispenser and remove waste bin. Note location
of mounting slots in the wall box portion of the cup dispenser (see Figure 7). The slots are for
affixing wallbox to building construction.
4. Put
cup dispenser in wall opening. Determine shimming required to obtain a good alignment with
fountain. Open and close door to ensure proper operation.
CAUTION:
Do not “suspend” cup
dispenser via the mounting slots - be sure to shim along bottom edge to bear the weight of the cup
dispenser.
5. Secure
cup dispenser in place. Use lag screws or bolts or bolts as required by wall construction.
6. Replace
waste bin.
6
FIG. 12
