(630) 574-8484
11
Elkay Manufacturing Company
Installation Manual (2000000350 Rev. A - 08/21)
In-Wall Filtered Water Dispenser
2.
Place the filter box into the wall opening and slide it up
against the bottom of the water dispenser. Make sure
the filter box is in alignment with the water dispenser
and, using four #8 flathead screws, start the screws to
hold the unit in place.
Do not completely tighten the screws until the filter
unit cover is installed and the fit between the water
dispenser cover and the filter cover is checked.
Note:
Some side-to-side and up-and-down movement of
the housing is capable to accurately align the filter
unit with the water dispenser.
3.
Replace the filter unit cover and check the gap
between the two covers. Adjust the filter box to create
an even gap all the way across the units. Tighten all
screws.
Note:
Create an even gap across the entire unit.
4. After aligning the two sections, remove the front cover
from the filter unit by removing the four flat head
screws from the right and left side of the cover using a
3/32 Allen wrench.
4.6.3 Connecting the Water Lines
1. Connect the 1/4 inch water line from the water
dispenser to the filter housing.
2. Connect the NFC wire.
NOTICE
Do not disconnect the 1/4 inch
tubing from the water valve at
the top of the water dispenser. This connection has
been factory tested to be leak-free and could result in
water leaking into the unit if this connection is
changed.
a.
Connect the 1/4 inch tube to the fitting below the
filter, as shown.
