Elkay Manufacturing Company
10
(630) 574-8484
In-Wall Filtered Water Dispenser
Installation Manual (2000000350 Rev. A - 08/21)
3. Using a bubble level, straighten the water dispenser
and attach it to the wall studs using four #8 flathead
screws.
4. Locate the electrical gang box, at the lower right-hand
corner of the water dispenser, and remove the cover.
CAUTION
Follow all safety
practices and industry
regulations and standards when connecting any
electrical device. A 15 AMP GFCI Circuit Breaker is
required for safe installation.
5.
Connect a 115V, 60Hz power supply to the water
dispenser. Route the wiring through the wall into the
bottom of the electrical gang box.
a. Route the appropriate electrical wiring through a
wiring clamp into the gang box.
b. Tighten the wiring clamp to prevent the wire from
being pulled out of the gang box.
c. Connect black wire to supplied voltage line (black)
wire and the white wire to neutral.
d. Use installer provided wire nuts to insulate the
connections.
e. If required by code a green grounding screw can
be used to connect a grounding wire inside the
gang box.
f. Reinstall the gang box cover.
NOTICE
Do not use a cord with a three
prong plug to power this unit.
Note:
The space behind that filter box is limited so make
sure any electrical wiring will not interfere with
mounting the filter box into the wall. Refer to "4.3
Critical Depth Dimensions" on page 8 for additional
information.
4.6.2
Installing the Filter Box
1.
For installation of the filter box below the water
dispenser, first replace the front cover of the water
dispenser to help locate and align the filter box under
the water dispenser.
NOTICE
I
t is recommended to attach the
front cover with the top two
mounting screws to prevent it from falling away from
the water dispenser while the filter unit is being
installed.
