INSTALLATION OF ELIXAIR E 2100 AIR PURIFIER
After finding a suitable place for the air
purifier, install it using the mounting bracket
provided.
A) Ceiling installation
(figure 3)
1) Attach the bracket with the enclosed
screws so that the control panel of the
purifier will be facing the direction where
the remote control is used. Make sure to
allow sufficient room on the opposite side
for the service door to open for removal of
the grid, the collector cells and the filters.
2) Drive in 2 locking screws in the bracket to
prevent the purifier from sliding in too far
while installing it.
3) Hold the unit horizontally and lift it next to the mounting bracket and push to the grooves of
the bracket all the way to the locking screws.
4) Fasten the remaining 2 locking screws.
5) Open the service door and remove the two transport supports which hold the collector
cells (figure 2).
6)
Remove the plastic wrapping from the active carbon filters
and install the filters in the
grooves above the cells. Close the door properly.
B) Wall installation
Use wall installation only when installation to the ceiling is not possible.
1) Attach the mounting bracket to the wall so that the grooves of the bracket run horizontally.
2) Drive in 2 locking screws in the bracket to prevent the purifier from sliding in too far while
installing it.
3) Lift the unit next to the mounting bracket and push it to the grooves of the bracket all the
way to the locking screws. Support the unit while you push it.
Notice that the service door opens sideways.
4) Fasten the remaining 2 locking screws.
5) Open the service door and remove the two transport supports which hold the collector
cells (figure 2).
6)
Remove the plastic wrapping from the active carbon filters
and install the filters in the
grooves above the cells. Close the door properly.