Elite MS1220, Руководство пользователя

Страница: 37 / 44

www.ELITETOOLS.co
Keep Working
Using the Depth Stop
If a kerfing or rabbet cut which does not cut through the workpiece is desired, use the Depth Stop Bolt to
control the depth of the cut.
WARNING! Only adjust the front Bolt. The rear Bolt is used to prevent the Blade from cutting the table
during normal cutting. Do not adjust the rear Depth Bolt.
1. Unlock the Head Lock-down, see page 9.
2. Raise the saw head assembly.
3. Push the Depth Stop to the left to use the Depth Stop Bolt setting.
4. Pull down on the saw head to check the current setting.
5. To change the setting, first loosen the knurled Depth Stop Nut on the Depth Stop Bolt. Turn the Depth
Stop Bolt clockwise to decrease depth and counterclockwise to increase depth. Tighten the Depth Stop
Nut after adjustment.
6. If needed, push the Depth Stop to the right to temporarily disable it.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit. The work area must not allow access by children or
pets to prevent injury and distraction.
2. Route the power cord along a safe route to reach the work area without creating a tripping hazard or
exposing the power cord to possible damage. Thepower cord must reach the work area with enough
extra length to allow free movement while working.
3. Allow room on both left and right of saw for extended workpieces.
4. Use a saw table, saw stand or other means to support the workpiece. Mount the Miter Saw so that the
surface is level to the ground, and additional supports provide a surface on the same level as the saw
table. If the work surface and any workpiece supports are not level, and on the same level, unwanted
bevel angles will appear in the cuts resulting in poor joinery.
5. Secure workpieces to the saw table using the Clamp or other clamping devices (not included). Secu-
ring the workpiece will provide safety by preventing kick back and by removing the need to hold workpie-
ces near the blade by hand. Clamping the workpiece will also improve cutting accuracy by preventing the
workpiece from moving during the cutting operation.
14