Elite MS1220, Руководство пользователя

Страница: 38 / 44

www.ELITETOOLS.co
Keep Working
General Operating Instructions
DANGER! MITER SAWS CAN QUICKLY AMPUTATE FINGERS IF MISUSED.
Keep hands well clear of cutting area.
1. Unlock the Head Lock-down, see page 9.
2. Make sure all adjustment knobs are tight (Miter Knob, Bevel Lock Knob, Fence and Table Extension
Knobs).
3. Blow any sawdust or debris away from the Fence. Place the work material against the Fence.
4. Align the marked location of the cut on the work material with the saw blade. Note: To prevent your wor-
kpiece from being cut too short, align the edge of the blade with your measured mark, keeping the rest of
the blade on the waste side of the cut.
5. Hold the work material in place using the Clamp. Ensure that the work material is level and supported
securely, use saw horses or supports if necessary.
6. Grip the Saw Handle, press one of the Trigger Locks with your thumb, and squeeze the Trigger to start
the Saw.
7. Press down lightly to cut the material. With narrow material, press straight down “chopping” the mate-
rial. With wide material, move the Blade across the material while cutting. Do not bear down on the mate-
rial, use light downward pressure. If the material binds the blade, release the trigger.
8. When the cut is completed, raise the blade assembly, release the trigger, wait for the Blade to stop
turning, release the Clamp and remove the work material from the saw.
9. To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the
tool indoors out of children’s reach.
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
WARNING
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Turn the Power Switch of the tool
off and unplug the tool from its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal
noise or vibration occurs, have the problem corrected before further use.
15