MZ04242018
6
Here’s how to set up your Wireless 5-12 volt trigger | Synchronization Instructions
Step1:
Connect one end of the 3.5 mm wireless 5-12 volt trigger cable to the RF remote.
Step 2:
Connect the other 3.5 mm end of the wireless 5-12 volt trigger cable to your projector
Step 3:
Make sure to unplug your screen from the power outlet
Step 4:
Hold the UP button on your RF remote
Step 5:
While holding the UP button, plug the screen back to the power outlet
Step 6:
Wait 5 seconds and then release the UP button
Step 7:
Your 5-12V wireless trigger should now be activated with your screen and ready to be used and able
to control your screen with your projector’s power cycle
Repeat the steps again if not successful.
(Please be aware, the projector on/off cycle may take longer to fully activate. It usually takes around 20-
30seconds for full off and on cycle each time)
For the following videos please visit:
•
Ceiling Installation Video
www.elitescreens.com/sakertabceilinginstall
•
Wireless Trigger Demonstration Video -
www.elitescreens.com/sakertabtriggerdemo
For more information, support or your local EliteScreens contact,
