JA10302020
U-00197
6
Note (after all springs have been attached):
Correct material installation
–Corners of the screen material are properly wrapped around the corner edges of the
frame and material is evenly tensioned and flat, creating a nicely taut surface.
Incorrect material installation
–The corners of the screen material are not properly wrapped along the edge of the
frame leaving the material with unbalanced tension and an uneven finish. To correct, detach springs from material at
the corner(s) where material does not lie flat along the edge of the frame, reposition the material so that it lies flat
and wraps along the edge of the frame, and reattach springs to the material.
Note:
Please make note of the yellow label and spring in the center of the frame. This is an indicator to start the
screen material installation process from the middle area of the frame.
How to avoid getting ripples on the screen’s material surface
Solution:
Pull and smooth out the material using your hand from the center to the corners, creating a nicely taut
surface as shown below
.
Edge Trim Installation
ATTENTION: THE TOP EDGE TRIM PIECE WITH THE LOGO SHOULD BE INSTALLED ON THE TOP.
Step 11
: Place the edge trim frame pieces over each end of the frame.
5
6
7
8
9
11
10
12
To avoid ripples forming in the material it is imperative that all of the corners are properly wrapped around the
edges as illustrated in the check mark diagrams.
3
4
1
2
