4
ASSEMBLING
1.
Wash all detachable parts and accessories before using for the first time (see ‘Care
and Cleaning’ section for instruction). BE SURE TO THOROUGHLY DRY ALL PARTS
BEFORE ASSEMBLING THE UNIT. DO NOT PLUG THE UNIT INTO THE ELECTRICAL
OUTLET BEFORE OR DURING ASSEMBLY OR WHILE CLEANING!
2.
Place the Juice Collector (E) onto the Motor Base (I). Place the Pulp Container (F) onto
the Motor Base (I) by tilting it forward underneath the Juice Collector (E) on the
opposite side of the spout: insert the top end first and then push in the bottom end.
(Fig.2)
3.
Insert the Grater/Filter (D) into position inside the Juice Collector (E). Make sure the
Grater/Filter (D) is locked in place on top of the Driving Shaft (H). (Fig. 3)
4.
Place the Pusher (A) into the Feeding Tube (B) on the Lid (C) and then place the Lid (C)
onto the Motor Base (I). (Fig. 3)
5.
Pull the Safety Clamp (J) up to lock all parts into place. Make sure the Safety Clamp (J)
is locked into the grooves located on both sides of the lid. (Fig. 4)
NOTE:
The Pulp Container (F) will remain loose.
6.
Place the Juice Jug Lid (K) on the Juice Jug (L) and then place the Juice Jug (L) under
the spout. Please note that there is a special opening on the Juice Jug Lid (K) to
accommodate the spout. (Fig.5 & 6)
NOTE: Using the Juice Jug (L) and Juice Jug Lid (K) helps to avoid
splattering and allows you to store juice in the refrigerator.
7.
Now you can plug the power cord into a wall outlet.
8.
To separate the foam from the juice when pouring the juice into a glass, insert the
foam separator by sliding it into the Juice Jug (L). (Fig.6)
