Elite Greenhouses 6'5" WIDE TITAN, Инструкции и иллюстрации

Страница: 26 / 32

26
FITTING THE DOOR HANDLES
The handles are fitted to the infill panel on each door (choose between 1st or
2nd panel down). Position the handle centrally, and mark the hole position.
Drill 7mm diameter holes (2 holes per door), then fit the handles, and secure
with a nut and bolt.
FITTING THE DOOR LOCK
The door lock must be fitted after the doors are in position
(Key Point). Undo the ring bolt from the
door lock, and insert the barrel through the hole in the panel from the outside. Reattach the ring bolt
to the barrel on the inside, and tighten.
Now attach the cam lever, washer and
screw to the door lock from the inside posi-
tion of the door. The lock will turn through
90 degrees both ways, so you must ensure
the cam (when fitted) is pointing skywards
(unlock position) and horizontal (locked
position)
Now using a cropped head bolt, attach the
domed pin to the bolt channel of the handed
door post on the left hand door (viewed
from outside). Move the pin up or down in
the channel so that the notch on the cam
locates comfortably when horizontal. Tight-
en all components.
FITTING THE ROOF CANOPY
This must be done AFTER the roof vent (s) is/are fitted.
The canopy is fitted on top of the ridge bar, and is slightly longer than the ridge. If your greenhouse
is over 8’ long, then the canopy will be made up using several pieces.
First sit the canopy on top of the ridge and position the canopies so that the overhang at each end of
the ridge is the same and that the end of the canopy is level with the outer edge of the roof corner
bars.
Drill through the ridge (7mm diameter hole) and canopy at each end . Insert a bolt, and secure on
the other side with a nut.
Now insert the canopy seal to each side of the
canopy into the seal channel, and feed along so
that it is level with the ridge at each end.