Elite Greenhouses 6'5" WIDE TITAN, Инструкции и иллюстрации

Страница: 15 / 32

15
The blank end will be fixed during general assembly. By drilling a 4mm hole in the door bar and
inserting a self tapping screw through it and into the facing slot in the side corner bar. Do the same
for the 2
nd
small angle door track support at the opposite end of the top door track.
When this has been achieved tighten all nuts.
Slide a bolt into the bolt slot in the built in base section, one at each end. Attach the angle base leg/
corner bracket so that it is pointing downwards. If you are fitting your greenhouse onto soft ground,
then do not fit the corner bracket yet. If you are on a patio, you will need to cut the bracket off level
with the bottom of the built in base and slide extra bolts into the bolt channel to be attached to the
anchor bracket (generally 1 every 2’). If you are on soil, the bracket will go into the ground at gen-
eral assembly.
N.B. Please note carefully the correct position of the main door support. The slotted holes at either
end are facing skywards NOT downwards. (Key point).
Please note, you only require approx. 150mm of beading in the inside ‘v’ groove of the door end
block glazing bars.