Elite Greenhouses 6'3" WIDE CRAFTSMAN, Инструкции и иллюстрации

Страница: 22 / 28

22
FITTING THE DOOR TO THE STRUCTURE
The door slides onto the frame from the left hand side. You may find it easier to slide the door be-
fore the lock is fitted.
Put the door bottom rail into the bottom door track (door end cill) and slide to the right, feed the
first wheel into the upper door track and move further to the right until the black draught excluder
butts up to the end glazing bars. Carefully ease the door past the glazing bar and feed in the second
wheel. Push further to the right until both draught excluders are butting up to both end glazing bars.
Carefully ease the door past the two glazing bars. The door will now run quite freely. To square up
the door with the spacing, undo the upper bolts holding the door track. There is a little play to facili-
tate “fine tuning” of the door.
N.B. Sometimes the door can be a little stiff prior to glazing but once
the glass has been inserted (the last job of the construction) the extra weight will make for smooth
running.
(Key Point).
FITTING THE DOUBLE DOOR LOCK
The door lock must be fitted after the doors are in position
(Key Point). Undo the ring bolt from the door lock, and
insert the barrel through the hole in the panel from the out-
side. Reattach the ring bolt to the barrel on the inside, and
tighten.
Now attach the cam lever, washer and screw to the door
lock from the inside position of the door. The lock will
turn through 90 degrees both ways, so you must ensure the
cam (when fitted) is pointing skywards (unlock position)
and horizontal (locked position).
Now using a cropped head bolt, attach the domed pin to the bolt channel of the handed door post on
the left hand door (viewed from outside). Move the pin up or down in the channel so that the notch
on the cam locates comfortably when horizontal. Tighten all components.
FITTING THE RAMP
The final aluminium piece of the greenhouse is the door end ramp cill. The ramp is attached to the
door end cill by engaging the nub of the door end cill to the ‘C’ groove of the ramp. The ramp is
now rotated to horizontal. Drill a hole at each end approx. 20mm in from the end of the ramp and
into the floor. Plug and screw.
If you are fitting onto soft ground, you must ensure that a solid material is underneath the ramp to
avoid damage when you step on the ramp to enter the greenhouse. You can lay a row of bricks
sunk to ground level, a concrete flag, a piece of aluminium base pressed into the ground to ground
level or something similar. You can then screw the ramp into the support material for a secure fix-
ing.