Elite Greenhouses 6'3" WIDE CRAFTSMAN, Инструкции и иллюстрации

Страница: 13 / 28

13
3. Slide 2 bolts into the bottom of each glazing bar and 3 bolts (only 1 if
greenhouse to be sited on soft ground) into the free end of each built
in base section. Attach the 2
nd
(of 2) bolt in the glazing bar to the hole
in the door end cill, but do not put a nut on yet. Remember, the door
end glazing bars are 95 mm longer than the rear end ones and do not
sit on top of the base (as the rear end glazing bars do), they go down
the side of the base and attached to the bottom cill.
4. Attach the rectangular plate (with 3 holes) to the 2 bolts inserted in the
glazing bars and the last bolt inserted into the built in base ensuring
that the glazing bar is tight down into the angle of the door end cill.
Attach the door end diagonal angle to the top bolt of the rectangular
plate. The 2 unoccupied bolts in the built in base sections will be used to anchor the green-
house to the floor, and attach the corner bracket.
5. Slide 2 bolts into the top of each glazing bar. The last bolt locates in the hole in the roof
corner bar, do not put a nut on yet.
6. Attach the main door track support (shaped like a letter ‘Z’ to be found with the door panels,
packet marked door) to the two bolts that secure the glazing bars to the corner bars. (Key
Point). This ‘Z’ shaped bar must be fitted with the two outside slots facing upwards (as illus-
trated) not downwards. (Key Point).
7. The two short horizontal angles attach to the top bolt in the
eave gusset plate and the vertical glazing bars.
8. When this has been achieved tighten all nuts.
9. Stand the frame up and bolt the door track to the main door
track support and the small angle door track support by in-
serting 4 bolts into the bolt slot of the door track. Position 3 of
these through the 3 holes in the door track support above the
door opening. Viewed from the outside, the door slides centre to
right. Position the door track in such a way that it is in line with
the left hand glazing bar and right hand corner bar. The small
angle door track support (which is to be fitted at the end of as-
sembly and before glazing) has 2 elongated holes at the top and
is blank at the bottom. Attach one of the holes to the bolt slot at
the back of the upper door track using the 4
th
bolt, and then by
using a self tapping screw, you can attach the blank end of the
bar to the continuous screw groove on the corner bar. See door
end assembly diagram
.
N.B. it is easier to fit the small door track support once the frames are
joined together. You will need to drill a small hole (4mm) in the bottom of the small angle
door track support to accommodate the self tapping screw.
10. Attach the corner bracket to the pre-inserted bolt closest to the end of the built in base, so that
it is pointing downwards. If you are fitting your greenhouse onto soft ground, then do not fit
the corner bracket yet. If you are on a patio, you will need to cut the corner bracket off level
with the bottom of the built in base and slide extra bolts into the bolt channel of the built in
base to be attached to the angle brackets (generally 1 every 2’). If you are on soil, the corner
bracket will go into the ground at general assembly.
N.B. Please note carefully the correct position of the main door track support. The slotted holes at
either end are facing skywards NOT downwards. ( Key Point).