Elite Greenhouses 6'3" WIDE CRAFTSMAN, Инструкции и иллюстрации

Страница: 10 / 28

10
8. Tighten all nuts.
9. Slide a bolt into the bolt slot in the built in base section, one at each end. The corner bracket is
approx. 400mm long and has 6 holes (4 at 1 end and 2 at the other). If you are fitting your green-
house onto soft ground, then do not fit the corner bracket yet. Attach the corner bracket (base an-
chors) so that it is pointing downwards by using the end of the corner bracket that has 2 holes (not
4) to the bolt channel of the built in base section.
N.B. It bolts only to the built in base and NOT to
the corner bars. If you are on a patio, you will need to cut the corner bracket off level with the bot-
tom of the built in base and slide extra bolts into the bolt channel to be attached to the angle brack-
ets (generally 1 every 2’). If you are on soil, the corner brackets will go into the ground at general
assembly.
N.B.
Roof Corner Bars are marked “R” on the outside, which indicates that they meet at the ridge.
They are also mitred at both ends.
If you have a powder coated greenhouse there is no letter “R” on the corner bar. You
must ensure
that the “middle” hole is nearer to the ridge plate than the eaves plate. (Key Point).