9
Installation of amber filter board
ZEPHYRUS
®
GelCube LED Imager is equipped with an
amber filter board for green light protection and gel
cutting purposes. Open the lid and install the filter
board so the gel cutting task may be conducted.
1.
Open the lid, cyan light will auto turn off
2.
Lift the lid to its maximum open angle
3.
Position the amber filter board with the hole
for hanging on lid in front
(Figure 8)
.
4.
Place the amber filter board onto the filter
board hanging tab so the filter board may hang
as shown in
(Figure 9)
.
5.
When hanging on the lid, make sure the two
small pins on the filter board are placed closely
against the lid.
6.
The installation is completed. One may turn
on cyan LEDs by
“
Scan button
”
for further gel
cutting purpose by using the provided gel
cutting knife.
Figure 8
Filter board
hanging tab
Small
pin
Amber Filter
Board
Figure 9
DISPLAY SCANS ON Monitor or Projector
The display from the scanner can be displayed on a television rather than the built in
scanner preview screen using the VGA port.
1. Set the television to VGA mode (see monitor
documentation for details).
2. Connect the included VGA cable to the video port on the monitor.
3. Connect the other end of the cable to the
VGA port on the back of the scanner.
4. Video output from the scanner can now be seen on the connected monitor including
the full menu interface.
Created by: VIJU
Instruction Manual ZEPHYRUS® Gel Cube Illuminator
Source: https://www.elisabeth.cz/en/product-zephyrus-gel-cube-cyanw-transilluminator.html
This file is owned by ELISABETH PHARMACON, spol. s r. o., It is issued for publication.
Version: 180220-01
Downloaded: 02.03.2020 09:17 online user
Page 9 of 16
