Eliet DZC750, Руководство пользователя

Страница: 71 / 106

71
Nederlands
• Remove all the dirt clinging to the bearing with a soft cloth.
• Apply a second round of spray to the bearings, particularly on the joints. The cleaner will
dissolve the grease that has dried op in the joint. This is necessary to ensure that new grease
can penetrate the joint.
• Blow compressed air into the bearing joints to enable the KLEENSPRAY to expel all the dirt.
• Wipe away all the spray and wait 10 minutes to allow any residue to evaporate.
• Now apply a new layer of lubricant. Spray good amounts of NOVATIO PTFE OIL into the joints
of the bearing seals and the bearing bushing.
• This is a thin lubricant with great penetrating properties. It is corrosion resistant and moisture
and dust repellent and also has great lubricating properties, even at high temperatures.
11.4.2.4 Lubricating chains
Because chains have a high rotation speed and don’t run through an oil reservoir, after some
operating hours the applied chain lubricant will have been propelled away or be full of dust and
dirt. To avoid wear and tear of chains, they must be lubricated after each operation. The machine
has three chain transmissions:
1. Duplex chain for driving the gearbox to the discharge jack
2. Duplex chain for transmission from the discharge jack to the blade axis
3. Simplex chain for transmission from the rollers to the seed reservoir drum
• For easy maintenance, these chain transmissions were all placed under the same protective
cover. (Read § 11.4.12 if necessary.)
• We recommend to clean the chain and wipe away the old lubricant that will inevitably contain
dust, before applying new lubricant. The use of KLEENSPRAY may help to soak off and dissolve
any old grease.
• Wipe away any old lubricant before applying new one.
• Because the chain transmissions are fast-moving drives, a sticky type of oil is best.
• Since both the chain inside and the contact surface with the gears need to be lubricated, ELIET
recommends using a combination of two lubricants.