Eliet DZC750, Руководство пользователя

Страница: 45 / 106

45
English
• It is therefore recommended to clean the machine after each use. Cleaning the machine can
also be regarded as a visual check. It offers an opportunity to timely notice any breakage or
need for lubrication.
Tip : clean the machine immediately after overseeding. Mud and soil then won’t have a chance to
dry up and stick to parts which makes cleaning and rinsing considerably easier.
Caution:
Wear suitable clothing for cleaning activities. Utility gloves are necessary.
The following points require special attention:
• Always remove the seed from the seed reservoir after an overseeding session (use a vacuum
cleaner to remove the seed from the deeper lying areas).
• Also check that the seed funnels are completely free.
• The engine should be clear of dust and dirt. More in particular the cooling fins, the exhaust and
the area around the exhaust must be clear. The area around the fuel cap must be kept clean to
avoid dirt entering the fuel tank. Blow away any dirt that might block the throttle control.
• Check and clean the air filter on a regular basis.
• Check and lubricate the chain drives.
• The bushings must be cleaned from sand and dirt that sticks to the lubricating grease. After
cleaning, apply new lubricant (see § 11.2 Lubricants for a list of lubricants).
• Use a dry cloth or soft brush for cleaning, and penetrating oil with MoS2 to remove grease and
lubricants. The latter is a lubricant and rust solvent at the same time.
• The transmission parts and hinges located under the large cover must be kept dust free as
much as possible. (Use the cleaning job to lubricate the chain drives; read § 11.4.2.)
• Remove the dirt above the vibration plates.
• Check whether the blades are damaged or bent (read § 11.4.7 Checking the blades). To enable
easy lifting of the machine for inspection of the blades from underneath, ELIET manufactured
a special DZC lifting jack (read § 11.4.13 Lifting the machine with a DZC jack).
• Clean the blade compartment and the discharge channel. Use a water sprayer to rinse off any
persistent dirt.
• A special hook is available to scrape off the dirt from the blade compartment and the
discharge channel. Its length takes away the need of crawling under the machine to perform
the maintenance. (stock code: MA 016 001 015).