Maple User Manual
16
Mode
setting of Pin Entry Mode to the controllers.
Anti Passback Reset
Time
This command allows you to reset the Anti-Passback Reset Time back
to null. For example, if the Anti-Passback Reset Time is at 13:00 the
anti-pass will no long apply from 13:00 hours onwards, unless
another badge/swipe IN/OUT takes place.
Lock Release Time
This command allow you to set the time duration for Door Lock to
remain operated each time it is commanded to turn on.
For further explanation of parameters, you may refer to particular hardware controller user
manual.
3.3.2.4
Send Control Signals
This command allows you to send control signal to controllers in the system.
Figure: Send Control Signal
Command
Description
Permanent
Lock Release
“On”
designates that the door is to be kept unlocked at all time. The door will only
be locked back when you select
“Off”
.
Inhibit Access
“On”
designates that all cardholders are suspended temporarily from entry/exit.
Access is granted only if you select
“Off”
.
Pin Mode
“On”
designates that entry is of CARD + PIN mode. To switch back to the CARD
mode, click on
“Off”
.
Anti-Passback
Mode
This option has 4 selections. You may select
“Off”
to disable antipassback, select
“Reader”
to enable anti-passback by reader, or select
“Timer”
to enable anti-
passback by timer. 4-Reader antipass-back is only applicable for EL2308 2-door
Содержание Maple
Страница 1: ...Maple User Manual Version 1 0 0 ...
