ELICA Majestic Sense, Инструкция по монтажу и эксплуатации, Страница: 25 / 84

25
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood.
Do not tile, grout or silicone this
appliance to the wall. Surface mounting only.
Operation
Control panel with 7 buttons
To select the functions of the hood you simply touch the
controls.
Automatic operation (sensor) and
connection with SNAP
®
and Eliba
hob (See related paragraph)
Button ON/OFF ‘Anti-condensation
Function’:
is used to prevent
condensation from forming on the
surface of the hood. To be activated
when needed.
‘Automatic anti-condensation
Function’:
the hood enables the
function every time it is switched on.
Automatic activation ON/OFF: with
the hood off, press and hold the
button (about 3 seconds until you
hear a "beep" sound signal) to enable
or disable the function.
Note: The anti-condensation
function, in any case, is only
activated with the motor started.
Attention! Even if this function is
never activated, perform anyway
the maintenance of the drain pan
periodically, as indicated in
section ‘Maintenance - Cleaning –
Maintenance of the drain pan’.
Button ON/OFF light
Press briefly to switch on or off the
lighting of the hob.
Press and hold to switch on or off the
ambient light (only certain models).
Button to select High and
Intensive speed
(suction power)
Press to activate High speed (Suction
power).
Press again to activate Intensive
speed (Suction power) (the button
flashes for 5 minutes then it returns
to medium speed (suction power).
Button to select medium speed
(suction power)
Button to select low speed (suction
power) – when flashing it indicates
you must wash the grease filter.
Button OFF motor (stand by)
Indicators of Filter Saturation
At regular time intervals, the hood signals the need to perform
filter maintenance.
Button on with steady light: perform grease filter
maintenance.
Button flashing: perform activated charcoal filter
maintenance.
Note:
Filter saturation signal is visible within the first
minute after switching off the hood; within this time, the
reset of saturation indicators must be performed.
Reset of filter saturation indicators:
Press and hold the button
Activation of saturation indicator activated charcoal
filter
Note: this operation must be performed with the hood off.
This indicator is normally deactivated; press and hold the
button to activate the function: the button lights
up with steady light.
To deactivate the function, press and hold the button
: the button lights up flashing.
Automatic operation (sensor), connection with SNAP
®
and Elica hob
Attention! The proper operation of the hood will depend on
the ’ Setting of parameters for Automatic Operation’ (see
dedicated section)
Note: Automatic operation with the hob is only possible with
specific hobs. For further details, please contact the official
dealer or authorised technical assistance centre.