ELICA EAS422SS, Инструкция по использованию, уходу и установке

Страница: 11 / 36

11
Maintenance
Cleaning
Cleaning
Do not spray cleaners directly to the control while cleaning
the Hood. The cooker hood should be cleaned regularly (at
least with the same frequency with which you carry out main-
tenance of the fat filters) internally and externally. Clean using
the cloth dampened with neutral liquid detergent. Do not use
abrasive products. Do not use chlorine base cleaners.
DO NOT USE ALCOHOL!
I
WARNING
Failure to carry out the basic cleaning recommendations of
the cooker hood and replacement of the filters may cause fire
risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate main-
tenance or failure to observe the above safety recommenda-
tions.
Metal grease filter
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean. Let filter dry
throughly before replacing it.
Turn off fan and lights. Allow lamps to cool.
1 Remove each filter by pulling the spring release handle
and then pulling down the filter.
A
2 Wash metal filters as needed in dishwasher or hot
detergent solution.
3 Reinstall the filter by making sure the spring release handles
are toward the front. Insert metal grease filter into upper
track.
4
Pull the spring release handle down.
5 Push up on metal filter and release handle to latch into place.
6 Repeat steps 1-5 for the other filter.
Replacing a LED lamp
The LED lights are replaceable by a service technician only.
See “Who to contact” section in the warranty for service
contact information.
Available accessories
Recirculating kit
To reduce the risk of fire or shock when the hood is used in
recirculation mode, use only the conversion kit models listed
below:
Recirculating kit: KIT02770
If it is not possible to vent cooking fumes and vapors to the
outside, the range hood can be used in the non-vented
(recirculating) version, using a charcoal filter. Recirculation Kit
is available from the dealer or an authorized parts distributor.
E
A
B
G
D
F
H
I
A
B
G
F
C
D
E
A. Ceiling
B. Vent cover
C. Soffit
D. 6” (15.2 cm) vent
E. Range hood F. Cabinet
G. Wall
H. 12” (30.5 cm) min. cabinet
height
I. 17” (43.2 cm) min. vent
cover height
NOTE:
12” (30.5 cm) high cabinets without a soffit may allow
the 6” vent and vent cover to be seen.
1
Cover the grill that protects the suction motor with the
carbon filter so that the slots on the filter correspond to
the pins on the sides of the motor protection grill.
2
Turn the carbon filter clockwise to block them (bayonet
fixing).
•
The charcoal filters cannot be cleaned. It should be
replaced every 4-6 months (depending on hood usage).
•
Remove the cable ties in the carbon filter to be able to
turning it clockwise.