ELICA EAS422SS, Инструкция по использованию, уходу и установке

Страница: 8 / 36

8
Venting outside through the wall
1 Measure from the bottom of the range hood liner to the
horizontal centerline of the vent opening (A).
A
B
C
D
A. Measurement A
B. Horizontal centerline of vent
opening
C. Range hood liner
D. 12” (30.5 cm) min. cabinet height
5 Remove the vent duct from the range hood liner. Transfer
measurement A to the cabinet back wall. Measure from the un-
derside of the cabinet.
6 Mark the cutout as shown. Use a saber saw or keyhole saw
to cut a round opening through the back of the cabinet and the
exterior wall for the vent.
A
B
C
A. Measurement A
B. Centerline
C. 6¼” (15.9 cm)
round cutout
Non-vented (recirculating) installation through the soffit/
cabinet
E
A
B
G
D
F
H
I
A
B
G
F
C
D
E
A. Ceiling
B. Vent cover
C. Soffit
D. 6” (15.2 cm) vent
E. Range hood F. Cabinet
G. Wall
H. 12” (30.5 cm) min. cabinet
height
I. 17” (43.2 cm) min. vent cover
height
1 Measure and mark the centerline of the cabinet to the soffit
above.
2 Measure from the bottom of the cabinet to the centerline of
the where the vent will come through the soffit. Mark the loca-
tion and use a saber saw or keyhole saw to cut a 5¾” (14.6 cm)
hole for the vent cover.
A
B
A. Vent cover
B. Centerline
* NOTE : For 12” (30.5 cm) high cabinets a 6¼” deep x 8” wide
(14.6 cm x 20.3 cm) rectangular opening in the cabinet top is
required for damper transition clearance.
3 Consider the cutout chart measures to make the openings
on the cabinet.
Complete preparation
1 If not yet attached, install the 6” (15.2 cm) vent transition
the top of the range hood liner using two 3.5 x 9.5 mm screws.
2 Locate side mounting bracket flush 1 cm to the bottom
of the cabinet side and against the inside of the front
cabinet face. Drill 1 ⁄
8
” (3 mm) pilot holes in 6 places, attach
a bracket using three 4.5 x 13 mm screws to each side of
the cabinet, and tighten.
Additional washers in hardware package are supplied as
spacers for cabinet walls thinner than ½”(13 mm).
A
B
C
D
A. 30” (76.2 cm) cabinet
B. Screws - 4.5 x 13 mm (8) C. Washers (optional)
D. Mounting bracket (2) (position for
30” [76.2 cm] cabinet)
Move the bracket
6
⁄
16
” (1 cm) from
the bottom side of the cabinet
5 Install the vent system according to the method needed.
Use caulking to seal the exterior wall or roof opening.