15
4.3
Replacing the fuse -------------------------------------------------------------
Turn off the main power switch (8)
and remove the power cable from
the outlet.
With the screw driver (U), turn the
center of the fuse holder (Fig.37).
Replace it with a new fuse, and then
tighten the fuse holder.
The fuse specifications and rated
values are as follows:
110V 1A / 125V
220V 0.5A/ 250V
Attention: Please select the fuse of the
same type, specification and rate value.
Fig.37
4.4 Replacing the chin-rest paper ------------------------------------------------
When the paper is depleted, pull
upward two fixing pins of the
chin-rest and place a new package of
paper, then fix the fixing pins again.
(Fig.38).
Fig.38
4.5
Adjusting the tightness of the slit width knob ---------------------------
If the slit width control knob is too
loose, the slit width may be out of
control. Rotate the screw clock-wise
on the right knob to adjust its
tightness with the screw driver (V),
When it is appropriate, stop doing it.
(Fig.39).
Fig.39
4.6
Adjusting the inclination of the illumination part ----------------------
If the inclination mechanism of the
illumination part is too loose,
fasten the screws on both sides of
the pivot point with the screw
driver (U) (Fig. 40).
Fig.40
