7
Fig11
8)
Removing the illumination part
shipping pad
This pad is used to protect the slit
mechanism of the illumination part
during shipping.
Remove the rubber band and gently
pull the pad out (Fig.12).
Fig.12
9)
Connecting plug
Fig.13
Insert the plug on the top of the
headrest part (D) into the socket of
the
lamp
cap
(26)
on
the
illumination part (A) (Fig.13).
Connect the two plugs below the
headrest part with the corresponding
output socket of the power box.
Insert the plug of the input power
cable (H) into the input socket of the
power box. .
Remove the cable clips from the
bottom of the work table with screw
driver (U) and wrap the output and
input
cables
respectively,
then
reattach them to the bottom of the
work table. (Fig14).
Fig.14
10) Assembling the Hruby lens (I) and
the Hruby lens guide plate (J)
Insert the Hruby lens (I) into the
Hruby lens holder (35) on the
headrest part. Be careful not to
touch the lens surface (Fig15.).
Fig.15
Place the Hruby lens guide plate (J)
into the main shaft hole of the base
part with the small end pointing to
the headrest part (Fig16).
